铝单板它在我们生活中的使用是很广泛的,但是对于铝单板还有很多行外的人不是很了解,铝单板它进行加工的时候会经常出现浪费的现象,难免会出现浪费的情况,下面就向大家介绍下:
Aluminum veneers are widely used in our daily lives, but there are still many laypeople who are not very familiar with them. When processing aluminum veneers, there is often waste, which is inevitable. Below is an introduction to everyone:
1.揉捏调直环节
1. Kneading and straightening process
调直这个环节,比较简略让型材产生曲折,操作员必定要注意调直所用的力度,假定力度过大就,或许型材就简略产生变形、收口、桔皮等现象,而力气过小就会产生型材调不直,构成型材曲折。
Straightening is a relatively simple process that can cause twists and turns in the profile. The operator must pay attention to the force used for straightening. Assuming that the force is too large, the profile may experience deformation, closing, orange peel, and other phenomena. However, if the force is too small, the profile may not be straightened, resulting in twists and turns in the profile.
2.揉捏装框
2. Kneading and framing
这个环节也是非常重要的,锯完定尺长度后,一般铝单板就要进行装框了,这时应该要注意了:这料是大料仍是小料,是带管料仍是平面模拉出来的料。
This link is also very important. After sawing the fixed length, the aluminum veneer usually needs to be framed. At this time, it should be noted that this material is large or small, whether it is a tube material or a flat die drawn material.
一般来说,大料和带管的料抬两头装框不简略构成曲折,但小料和平面模拉出来的料,抬两头就很简略构成曲折,这时就应该从两头向中心挨近进行抬料装框。但有的型材即便这样还不可,这时咱们就需要把这类料放在已时效的型材上再抬到框里。
Generally speaking, lifting the two ends of large materials and materials with pipes to frame is not a simple form of twists and turns, but lifting the two ends of small materials and materials pulled out of the flat mold is a simple form of twists and turns. At this point, the material should be lifted and framed from both ends closer to the center. But even if this is not possible for some profiles, we need to place these materials on the aged profiles and then lift them into the frame.
3.表面处理上架
3. Surface treatment on shelf
坯料经时效,硬度已达标,型材不会那么容易变弯曲,但是在上架时还是要注意,两端抬料时,尽量避免上下大力波动,避免铝单板出现弯曲的情况。
After aging, the hardness of the billet has reached the standard, and the profile is not prone to bending. However, it is still important to pay attention when placing it on the shelf. When lifting the material at both ends, try to avoid strong fluctuations in the upper and lower directions to avoid bending of the aluminum veneer.
This article is published by the aluminum plate manufacturer. Have you gained some understanding of these contents? For more information, please click on: //www.renttoplux.com We will have more exciting content waiting for you to check out.